1. Make sure the wall transformer is not plugged in before you use the Unit.
2. Open the Unit by twisting the cap counter clockwise. Lift the cap from the stainless steel tank and place the cap on its top so the baskets are facing you. 
3. Using LensComfort MultiPurpose Solution, fill the tank to the raised fill line marked on the side of the tank. A clear plastic measuring cup has been provided. Fill to the line indicated on the side and pour into the tank. DO NOT FILL BEYOND THE LINE AND DO NOT UNDERFILL AS COMPLETE CLEANING OR DISINFECTION WILL NOT TAKE PLACE.
4. Open up the lens basket in which you will place your first lens.
5. Each basket is marked “R” for right (it has a raised nub) and “L” for left, which makes it easy to identify into which basket you have placed your lenses.
6. Remove your right lens from your eye; center it on the dome in the appropriate basket “R”.
7. Before closing the basket, gently rub your finger around the outside of the basket to assure that you will not pinch the lens when the basket is closed. Close the basket and repeat for the other lens.
8. Place the cap and baskets back into the tank and gently turn the cap clockwise until tight.
9. Once the cap is tightened and sealed, plug the cord into the jack at end of the Unit then plug the wall transformer into a receptacle. The amber light will glow on the control panel signifying that the Unit has power and the 15-minute cleaning cycle has begun.
10. At the end of the 15-minute cleaning cycle the amber light will go out and the green “cycle completed” light will begin blinking. Unplug the Unit from the wall socket.
11. The Unit must be left sealed for 15 minutes. If lenses are stored overnight, do not break the seal on the tank until you are ready to wear your lenses.
12. When you are ready to reapply your lenses unscrew the cap from the Unit. Remove the cap and baskets and gently shake any excess fluid from them. Place the cap on its back.
13. Discard the soiled solution and gently shake out any excess solution from the tank.
14. Prior to applying your lenses rinse them thoroughly with LensComfort MultiPurpose Solution.
15. After applying your lenses swab out the tank with a clean soft cloth and rinse the lens baskets with warm water and let both air-dry.
16. You may store your lenses in LensComfort MultiPurpose Solution for up to 30 days.
17. It is recommended that after storage (over 24 hours) plug in the Unit and run a complete cycle before wearing. Unplug the Unit after each use.
